115年 - 機車駕照筆試_英文 151-200（2026/01 更新）#144927

151.When sounding the horn in an emergency or dangerous situation, theprinciple is to use a single beep, and (A) do not sound the horn continuously 3times, (B) each beep should not exceed half a second, (C) all of the above.

152.Under which of the following conditions should the headlight be turned onwhile riding? (A) When encountering dense fog, rain, dusk, or poor visibility,(B) When passing through a tunnel, (C) All of the above.

153. Regarding the color of the motorcycle brake light, which of the following iscorrect? (A) Red, (B) Orange, (C) Yellow.

154.Concerning the regulations for motorcycle fog lamps, which of the following iscorrect? (A) Front and rear fog lamps should be either one or two lamps, (B)Front fog lamps must be yellow, pale yellow, or white; rear fog lamps must bered, (C) All of the above.

155. The color of the motorcycle headlight should be (A) White or pale yellow, (B)Blue, (C) No regulation.

156.Regarding the regulations for brake lights, which of the following is incorrect?(A) The light color should be amber (B) When the brake is applied, the lightshould remain steady and must not flash (C) The light should be red

157. The color of the turn signal light should be (A) Red (B) Yellow (C) Orange

158.What is the regulation for the tire diameter of small and light motorcycles? Itshould be (A) Between 300 mm and 420 mm (B) Between 200 mm and 400mm (C) Between 250 mm and 350 mm

159. The curb weight (including battery) of small and light motorcycles should be(A) Under 75 kg (B) Under 70 kg (C) Under 65 kg

160.Regarding the heat insulation protective device on motorcycle exhaust pipes:(A) It does not affect riding operation, so it is not required (B) It is optional andmay or may not be installed (C) To prevent burns to others, it is required to beinstalled

161.Which of the following regarding motorcycle equipment is incorrect? (A)Horns that emit different tones are not allowed to be installed (B) Rearviewmirrors on both the left and right sides must not be removed (C) Mudguardsmay be left uninstalled

162.After how many years from the motorcycle's manufacture date is a temporaryinspection required when transferring ownership? (A) 5 years (B) 7 years (C)10 years

163. When a motorcycle is registered as temporarily out of service, what is themaximum allowed period? (A) 1 year (B) 1.5 years (C) 2 years

164.For a vehicle that has been scrapped: (A) It is not allowed to apply forregistration, inspection, and licensing again (B) It can apply for registration,inspection, and licensing after repairs (C) There is no regulation

165.If a motorcycle is severely damaged in a traffic accident and repaired, whichinspection must be carried out? (A) Regular inspection (B) Temporaryinspection (C) License plate inspection

166. The maximum overall height of a motorcycle shall not exceed: (A) 2 meters (B)2.5 meters (C) 3 meters.

167.The function of installing rearview mirrors on a motorcycle is to: (A) increasevehicle stability (B) allow the driver to conveniently groom themselves (C) helpthe driver increase visibility on both sides.

168.For a scooter-type (continuously variable transmission) motorcycle, the brakelevers are controlled as follows: (A) right hand controls the front brake, lefthand controls the rear brake (B) left hand controls the front brake, right handcontrols the rear brake (C) both left and right hands simultaneously control thefront and rear brakes.

169.If a vehicle is parked unused for a long time, how often should it be started for3-5 minutes each time to maintain optimal engine starting condition? (A)Quarterly (B) Weekly (C) Monthly.

170. The normal exhaust color of a gasoline engine is: (A) black (B) bluish-white (C)colorless.

171.If the exhaust color of a motorcycle engine is black, it may be due to (A)complete combustion of gasoline (B) incomplete combustion of gasoline (C)burning of engine oil.

172.Which gas in motorcycle exhaust emissions is the main contributor to thegreenhouse effect on Earth? (A) Carbon monoxide (B) Carbon dioxide (C)Water vapor.

173. When checking the motorcycle engine oil, you should (A) turn off the engine(B) park on a flat surface (C) both of the above.

174. Besides regular inspection, motorcycle engine oil (A) should be replacedregularly (B) does not need to be replaced (C) depends on the brand of the oil.

175. When adding engine oil, it should be added through which part? (A) Oildipstick hole (B) Engine oil filler cap (C) Fuel tank cap.

176.Should the motorcycle oil filter be replaced? (A) Depends on the brand ofengine oil (B) No need to replace (C) According to the motorcycle user manualspecifications.

177. At night or in dark places, which lighting tool should NOT be used whenchecking the battery fluid? (A) Flashlight (B) Lighter (C) Electric work light.

178. What substance should be applied to the battery terminals to preventcorrosion and ensure good conductivity? (A) Paint (B) Grease (C) Tar.

179. The power source for the motorcycle starter motor comes from: (A) Generatorsupply (B) Battery supply (C) Engine supply.

180.The main purpose of installing an air filter on a motorcycle is: (A) To preventsand and dust in the air from damaging the cylinder (B) To reduce motorcycleoperating noise (C) To filter exhaust emissions and reduce pollution.

181. When tire pressure is insufficient, it is likely to cause (A) wear on both sides ofthe tire (B) wear in the center of the tire (C) lighter steering.

182. When tire pressure is insufficient, it is likely to cause (A) wear on both sides ofthe tire (B) increased fuel consumption (C) all of the above.

183. When tire pressure is too high, it is likely to cause (A) wear on both sides ofthe tire (B) wear in the center of the tire (C) increased fuel consumption.

184.When tire pressure is too high, it is likely to cause (A) accelerated damage tothe vehicle's shock absorbers (B) wear in the center of the tire (C) all of theabove.

185. Severe wear on the center tread of the tire is caused by (A) tire pressurebeing too low (B) tire pressure being too high (C) vehicle overload.

186. Excessive tire wear (A) does not cause danger (B) provides more comfortableriding (C) affects vehicle steering and braking distance.

187.When the tread depth of a motorcycle tire is less than how much should it bereplaced? (A) 2 millimeters (B) 1.5 millimeters (C) when it reaches the tire wearindicator.

188. The motorcycle tire specification 3.50-10-8PR means (A) tire width is 3.5inches (B) tire inner diameter is 10 inches (C) both of the above.

189.The main items a driver should check regarding tires are (A) whether the tirepressure is normal (B) whether the tire surface has cracks, damage, orabnormal wear (C) both of the above.

190. In tire construction, which part has the weakest strength? (A) tread (B)sidewall (C) bead.

191.When should tire pressure be checked? (A) After driving when the tiretemperature is higher than normal (B) Before driving when the tiretemperature is at normal temperature (C) At any time.

192.Low tire pressure can cause (A) Tire sidewall damage leading to blowouts (B)Increased rolling resistance resulting in higher fuel consumption (C) Both ofthe above.

193.Tires should be protected by (A) Avoiding proximity to heat sources (B)Avoiding contact with mineral oils and related substances (C) Both of theabove.

194. It is recommended to use tires that are no more than (A) 3 years (B) 6 years(C) 9 years old since manufacture.

195.What is the primary function of the tread on motorcycle tires? (A) Waterdrainage and increased traction (B) Increasing driving speed (C) Preventingsurface cracking of the tire.

196. Tire manufacturing date code: MMD1213 indicates (A) December 2013 (B) the13th week of 2012 (C) the 12th week of 2013.

197.The dangers of tire tread being too shallow: (A) Affects tire friction and grip,easily prolonging braking distance and causing accidents (B) Poor waterdrainage on rainy days, increasing the risk of slipping and losing control (C) Allof the above.

198.Regarding the use of motorcycle rearview mirrors, which is inappropriate? (A)When traveling very close to the vehicle ahead, you should check therearview mirror to facilitate overtaking (B) Before riding, adjust the rearviewmirrors to angles and positions that make it easy to observe vehicles or roadconditions behind (C) You can adjust the rearview mirrors while waiting at ared light.

199.When purchasing a helmet: (A) It must have a certification label approved bythe Standards Inspection Bureau (B) You should choose a helmet with brightcolors or reflective materials (C) All of the above.

200.After a helmet has suffered a strong impact: (A) It should not be used again(B) It can continue to be used if there is no visible damage (C) It can continueto be used if it is within 3 years from the manufacturing date and has novisible damage.